Skip to main navigation Skip to search Skip to main content

Residual stress of as-deposited and rolled wire+arc additive manufacturing Ti–6Al–4V components

  • F. Martina
  • , M. J. Roy
  • , B. A. Szost
  • , S. Terzi
  • , P. A. Colegrove
  • , S. W. Williams
  • , P. J. Withers
  • , J. Meyer
  • , M. Hofmann

Research output: Contribution to journal › Article › Research › peer-review

Abstract

Wire + arc additive manufacturing components contain significant residual stresses, which manifest in distortion. High-pressure rolling was applied to each layer of a linear Ti–6Al–4V wire + arc additive manufacturing component in between deposition passes. In rolled specimens, out-of-plane distortion was more than halved; a change in the deposits' geometry due to plastic deformation was observed and process repeatability was increased. The Contour method of residual stresses measurements showed that although the specimens still exhibited tensile stresses (up to 500 MPa), their magnitude was reduced by 60%, particularly at the interface between deposit and substrate. The results were validated with neutron diffraction measurements, which were in good agreement away from the baseplate. This paper is part of a Themed Issue on Measurement, modelling and mitigation of residual stress.

Original languageEnglish
Pages (from-to)1439-1448
Number of pages10
JournalMaterials Science and Technology (United Kingdom)
Volume32
Issue number14
DOIs
Publication statusPublished - 21 Sept 2016
Externally publishedYes

Keywords

  • 3D printing
  • Additive manufacturing
  • Titanium

Cite this